What are the installation steps of the anti-collision lifting column
Release time:
2022-02-21
What are the installation steps and installation spacing of the anti-collision lifting column? The following is a small series of Qi Xinlong to tell you about the answer.
What are the installation steps and installation spacing of the anti-collision lifting column? The following is a small series of Qi Xinlong to tell you about the answer.
The installation steps of the anti-collision lifting column are as follows:
1. Foundation pit width: 500mm Foundation pit depth: 1200mm Foundation pit length is determined according to the actual intersection and the number of pillars.
2, laying the bottom datum plane in the foundation pit most. The ground floor is laid with bricks. The thickness of masonry layer is 200mm. Note: Masonry layer shall be paved and shall not have inclination angle.
3, laying drainage channels: on the pre-laid gravel with bricks to make drainage channels. Drainage channel width: 100mm height: 100mm note: bricks on both sides of the drainage channel must be laid flat without inclination angle. The bottom of the drainage channel should be inclined to facilitate drainage.
4. Place lifting column: after the drainage channel is completed, put it in sequence according to the plan.Lifting column, Adjust the horizontal angle to ensure that the lifting column is flush with the road (very important). Note: When placing the lifting column, the reserved wires should be oriented uniformly. Equipment drain holes shall be aligned with the drain.
5, fixed equipment: to ensure that the equipment and the ground level, fill in a small amount of cement to fix the equipment. Note: When fixing the equipment, remember to ensure that the equipment is not tilted due to shifting. The amount of cement filled shall be subject to the ability to fix the equipment, and there is no standard amount.
6. Equipment wiring: TV line uses RVV3 * 2.5 specification wire, LED warning light uses 4*1.5 specification wire. After connecting the line, plug the PVC pipe into the control box. Note: PVC pipe should not be glued until the power test is successful.
7. Wiring of control box: according to the diagram, the connection method of control box is shown. The motor lines are respectively connected to the positive and negative lines of the motor and the LED lamp group of the common line to connect the positive and negative lines of the lamp group. Note: Do not connect the reverse motor line, otherwise it will cause the lifting column to rise and fall in the opposite direction to the remote control.
Hebei Qi Xinlong Intelligent Technology Co., Ltd. is a research and development, design, production, sales and service in one of the anti-terrorism equipment manufacturers. Main products include: automatic lifting column, semi-automatic lifting column, landscape fixed column, flap barricade, tire breaker, etc. Tel: 13930748833.
Key words:
Installation steps of anti-collision lifting column
Previous Page
Previous Page:
Next page:
recommend News
Advantages of electric lifting column
2024-03-01
Maintenance of electric lifting column
2024-02-29